2016 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE

No. 17 Cooling System Concerns-Overheating: Notes

17 COOLING SYSTEM CONCERNS-OVERHEATING
DESCRIPTION 
  • Engine runs at higher than normal temperature/overheats.
POSSIBLE CAUSE 
  • Engine heat generation amount is excessive
    • Engine speed is high and remains high for continuous long periods
  • PCM DTC is stored
  • Improper operation of A/C system
  • Insufficient air blow volume
    • Cooling fan inoperative
    • Fan rotation speed decreases (such as generator malfunction) due to battery voltage decrease
  • Cooling system cap malfunction
  • Cooling fan motor assembly malfunction
  • Cooling fan motor connector malfunction
  • Improper indication of low engine coolant temperature indicator light and/or high engine coolant temperature warning light
    • ECT sensor No. 1 malfunction
    • Instrument cluster malfunction
  • Blown fuse
  • Engine coolant system malfunction
    • Engine coolant performance deterioration
    • Coolant leakage (engine internal, external)
    • Improper water/anti-freeze mixture
    • Thermostat malfunction (not fully open)
    • Radiator malfunction (clogging)
  • Improper engine coolant level
    • Leakage around heater unit in passenger compartment
  • Drive belt damage
CAUTION:
  • Verify the malfunction symptom according to not only the PID value but also the symptom troubleshooting.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.