2016 Mazda 5 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE

No. 23 A/C Does Not Work Sufficiently: Notes

NO. 23 A/C DOES NOT WORK SUFFICIENTLY DESCRIPTION AND POSSIBLE CAUSE

23 A/C DOES NOT WORK SUFFICIENTLY
DESCRIPTION
  • A/C compressor magnetic clutch does not engage when A/C switch is turned on.
POSSIBLE CAUSE
  • Improper refrigerant charging amount
  • Refrigerant pressure sensor malfunction
  • Evaporator temperature sensor malfunction
  • Instrument cluster malfunction (does not receive A/C request switch from climate control unit or transmit it to PCM)
  • Climate control unit malfunction (A/C switch malfunction or climate control unit does not determine A/C request or transmit the A/C request signal.)
  • Communication error between instrument cluster and climate control unit
  • Communication error between PCM and instrument cluster
  • Poor ground of magnetic clutch
  • Open the magnetic clutch
  • A/C relay is stuck open.
  • Seized A/C compressor
  • Open circuit in wiring harness between A/C relay and PCM
  • Open circuit in wiring harness between A/C relay and ignition switch (IG2)
  • Open circuit in wiring harness between A/C relay and battery
  • Open circuit in wiring harness between A/C relay and magnetic clutch
  • PCM malfunction
G13726509Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.