2016 Mazda 5 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Rod operation

Engine speed 4, 400 RPM
Below Above
Shutter valve actuator Operate Not operate
  • If the rod operation is not as specified, inspect as follows:
  1. Stop the engine.
  2. Connect the M-MDS to the DLC-2.
  3. Verify that DTC P0661:00 or P0662:00 is not displayed.
  4. Inspect the variable intake air solenoid valve. (See VARIABLE INTAKE AIR SOLENOID VALVE INSPECTION .)
  • If the variable intake air solenoid valve is not normal, replace the variable intake air solenoid valve. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  • If the variable intake air solenoid valve is normal, inspect the following:
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.