Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Mazda 5 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Ignition Switch Removal/Installation

Disconnect the negative battery cable.
Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION .)
Detach the tab A shown in the figure.

Courtesy of MAZDA MOTORS CORP.
Remove the ignition switch connector.

Courtesy of MAZDA MOTORS CORP.
1. Pull the lock lever in the direction of the arrow shown in the figure and release the lock.
2. Disconnect the ignition switch connector.
Remove the ignition switch.

Courtesy of MAZDA MOTORS CORP.
1. Push the tab shown in the figure.
2. Remove the ignition switch.
Install in the reverse order of removal.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.