Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Mazda 5 TouringFACTORY OEM SERVICE PROCEDURE
Input/Turbine Speed Sensor Removal/Installation
CAUTION:
- Do not allow foreign material or water to penetrate the connector. Otherwise, it could cause poor contact and corrosion.
- If the removed input/turbine speed sensor installation bolt is reused, it may cause ATF leakage. Always use a new bolt.
- A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent ATF leakage from the installation bolt hole which passes through the component.
- When installing the input/turbine speed sensor, verify that there is no foreign material on the sensor such as metal shavings. If there is foreign material on the sensor part for the input/turbine speed sensor such as metal shavings, the sensor output will malfunction due to magnetic flux and result in deterioration in the control.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION .)
- Disconnect the negative battery cable.
- Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
- Remove in the order shown.
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
