Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Mazda 3 SV, Standard TransFACTORY OEM SERVICE PROCEDURE
Component Locations
Select a section or procedure below to view factory instructions:
Active Air Shutter SystemAir Bag System (Standard Deployment Control System)Air Bag System (Two-Step Deployment Control System)Automatic Transaxle - Overhaul (FW6A-El)Automatic Transaxle (Service Information)Automatic Transaxle Shift MechanismBody Control SystemBody PanelsBrake SystemCHARGING SYSTEM (WITHOUT i-ELOOP)Charging System (I-ELOOP)Doors And LiftgateDriveshaftDynamic Stability Control SystemElectric Power Steering SystemEmission SystemEngine Control SystemEngine Cooling SystemEngine MechanicalEngine Mechanical Intake-Air SystemEngine Mechanical Lubrication SystemEntertainment SystemExterior TrimFront AxleFront Suspension SystemFuel SystemGlass/Windows/MirrorsHVAC Basic SystemHVAC Control System (Full-Auto Air Conditioner)HVAC Control System (Manual Air Conditioner)Ignition SystemInstrumentation/Driver InfoInterior TrimLighting SystemManual Transaxle (C66M-R)Manual Transaxle Shift MechanismManual Transaxle ClutchParking Brake SystemPower SystemsRear AxleRear Suspension SystemSeat Belt SystemSeat SystemSecurity And Lock SystemStarting SystemSunroof System
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.