2014 Mazda 3 SV, Automatic TransFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Pre-Inspection

  1. Park the vehicle on level ground, in an unloaded condition*, with the wheels straight forward.

    *: Unloaded condition, fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.

  2. Inspect the tire pressure.
  3. Inspect the wheel bearing play.
  4. Inspect the wheel runout.
  5. Rock the vehicle, and verify that there is no looseness in the steering wheel joint and suspension ball joint.
  6. Rock the vehicle, and verify that the shock absorber operates properly.
  7. Measure height H from the center of the wheel to the fender brim.
  8. Verify that the difference between the left and right dimension H is within the specification.
    • If it exceeds the specification, repeat the Step  2 - 7.

    Standard specification 

    10 mm {0.39 in} or less 

    Fig 1: Identifying Fender Brim Measurement Point
    G09782910Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.