Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Mazda 3 SV, Automatic TransFACTORY OEM SERVICE PROCEDURE
Intake Manifold Vacuum Inspection
- Verify the air intake hoses are installed properly.
- Start the engine and let it idle.
- Disconnect the vacuum hose between the intake manifold and purge solenoid valve from the intake manifold
- Connect a vacuum gauge to the intake manifold and measure the intake manifold vacuum.
- If not within specification, inspect the following:
SpecificationÂ
-60.0 kPa {-450 mmHg, -17.7 inHg}Â
NOTE:- Air suction can be located by the engine speed change when lubricant is sprayed on the area where suction is occurring. Check the following places:
- Air suction at throttle body, charge air cooler, intake manifold and PCV valve installation points
- Engine compression (See COMPRESSION INSPECTION .)
- Air suction can be located by the engine speed change when lubricant is sprayed on the area where suction is occurring. Check the following places:
- If not within specification, inspect the following:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.