2014 Mazda 3 SV, Automatic TransFACTORY OEM SERVICE PROCEDURE

Main Fuse Removal/Installation

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure.
    Fig 1: Identifying Main Fuse
    G09784358Courtesy of MAZDA MOTORS CORP.
  3. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, and pull up the main fuse cover in the direction of the arrow (2) shown in the figure to detach the main fuse cover tab from the main fuse.
    Fig 2: Pulling Up Main Fuse Cover
    G09784359Courtesy of MAZDA MOTORS CORP.
  4. Remove the main fuse cover.
  5. Remove the nuts.

    Without i-ELOOP 

    Fig 3: Main Fuse Cover Related Replacement Components With Torque Specifications (Without I-ELOOP)
    G09784360Courtesy of MAZDA MOTORS CORP.

    With i-ELOOP 

    Fig 4: Main Fuse Cover Related Replacement Components With Torque Specifications (With I-ELOOP)
    G09784361Courtesy of MAZDA MOTORS CORP.
  6. Remove the main fuse.
  7. Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.