Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Mazda 3 SV, Automatic TransFACTORY OEM SERVICE PROCEDURE
Auto light system
NOTE:
- There are two types of personalization procedures: one using the M-MDS and the other using the center display.
| Personalization features | Setting contents | Setting procedure |
|---|---|---|
| Auto light sensor sensitivity can be changed. | Not Adopted./Dark/Medium Dark/Medium/Medium Light/Light | M-MDS is used. (See CONTROL SYSTEM PERSONALIZATION FEATURES SETTING PROCEDURE .) |
| Light/Medium Light/Medium/Medium Dark/Dark | Center display is used for the setting. (See CENTER DISPLAY PERSONALIZATION FEATURES SETTING PROCEDURE .) |
|
| Returns the setting content of the lighting system to the initial setting. | No/Yes | Center display is used for the setting. (See CENTER DISPLAY PERSONALIZATION FEATURES SETTING PROCEDURE .) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
