2013 Mazda CX-5 Touring, AWDFACTORY OEM SERVICE PROCEDURE

No.13 Knocking/Pinging-Acceleration/Cruise: Notes

DESCRIPTION & POSSIBLE CAUSE

13  KNOCKING/PINGING-ACCELERATION/CRUISE 
DESCRIPTION 
  • Sound is produced when air/fuel mixture is ignited by something other than spark plug, (e.g., hot spot in combustion chamber)
POSSIBLE CAUSE 
  • Poor fuel quality
    • Fuel RON is not specified
    • Excessive cleaning agents added in fuel
  • Combustion temperature is high
    • Engine overheating due to cooling system malfunction
    • Carbon accumulation (production of heat spot)
    • Plug thermal value is low
    • Plug malfunction (production of heat spot)
  • Ignition timing for calculating PCM is incorrect
    • PCM DTC is stored
    • Estimated intake air amount is deviated
      • ECT sensor No.1 or related circuit malfunction
      • IAT sensor No.2 (integrated in MAP sensor) or related circuit malfunction
    • Temperature correction is incorrect
      • Air leakage or restriction in intake-air system
      • MAF sensor or related circuit malfunction
      • MAP sensor or related circuit malfunction
    • KS or related circuit malfunction
    WARNING: The following troubleshooting flow chart contains the fuel system diagnosis and repair procedures. Read the following warnings before performing the fuel system services:
    • Fuel vapor is hazardous. It can easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel.
    • Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injury or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete "BEFORE SERVICE PRECAUTION" and "AFTER SERVICE PRECAUTION" described in this manual. (See BEFORE SERVICE PRECAUTION ). (See AFTER SERVICE PRECAUTION ).
    Factory Service Tools

    Use the Manual With the Right Hardware

    Pair factory procedures with proven DIY tools so the instructions are easier to execute.

    Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

    When to See a Mechanic

    Stop DIY work and contact a certified mechanic immediately if any of the following apply:

    • • You smell fuel, burning insulation, or see smoke.
    • • Brakes feel soft, pull hard to one side, or make grinding noises.
    • • The engine overheats, stalls repeatedly, or misfires under load.
    • • You are missing required tools, torque specs, or safe lifting equipment.
    • • You are not confident in the next step or safety outcome.