2012 Mazda Mazdaspeed3 L4-2.3L TurboFACTORY OEM SERVICE PROCEDURE

Programming and Relearning





PCM CONFIGURATION [MZR 2.3 DISI Turbo]

CAUTION:
- If the wheel and tire sizes are changed, a discrepancy with the speedometer needle whereby it exceeds the allowable range could result in a malfunction. If the wheel and tire sizes are changed, perform the following procedure to change the tire size parameter setting. Parameter Setting Procedure When Tire Size Is Changed

1. Connect the M-MDS (IDS) to DLC-2.

Factory service manual diagram





2. After the vehicle is identified, select the following items from the initial screen of the M-MDS (IDS).
a. "Module Programming"

3. Select "Programmable Module Installation".

4. Select menu in the "PCM".

5. Perform the configuration according to the directions on the screen.

6. Retrieve DTCs by the M-MDS (IDS), then verify that there is no DTC present.

- If a DTC(s) is detected, perform the applicable DTC inspection. Engine - DTC Table

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.