Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mazda MX-5 Miata L4-2.0LFACTORY OEM SERVICE PROCEDURE
Vehicle Speed Sensor: Testing and Inspection
VEHICLE SPEED SENSOR (VSS) INSPECTION [SJ6A-EL]
CAUTION:
- Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not enter the connector when disconnecting it.
1. Remove the battery cover.
2. Disconnect the negative battery cable. Removal and Replacement
3. Remove the tunnel member component.
4. Remove the middle pipe. Service and Repair
5. Remove the insulator.
6. Mark the manual shaft lever component as shown in the figure.
7. Separate the manual shaft lever component from selector lever.
8. Disconnect the VSS connector.
CAUTION:
- Do not apply a shock in the VSS.
- Do not damage the terminals.
9. Measure the resistance between the VSS terminals.
- If there is any malfunction, replace the VSS. Service and Repair
VSS resistance
- 560-680 ohm
10. Connect the VSS connector.
11. Align the mark of the manual shaft lever component as shown in the figure.
12. Install the manual shaft lever component installation nut.
Tightening torque
- 10.8-14.7 Nm {111-149 kgf-cm, 96.4-129.3 in-lbf}
13. Install the insulator.
Tightening torque
- 8-11 Nm {82-112 kgf-cm, 72-97 in-lbf}
14. Install the middle pipe. Service and Repair
15. Install the tunnel member component.
16. Connect the negative battery cable. Removal and Replacement
17. Install the battery cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
