2012 Mazda MX-5 Miata L4-2.0LFACTORY OEM SERVICE PROCEDURE

Engine Control Module: Service and Repair





PCM REMOVAL/INSTALLATION [LF]

1. When replacing the PCM, perform the following:

- PCM configuration Programming and Relearning

2. Remove the battery cover.

3. Disconnect the negative battery cable. Removal and Replacement

4. Remove the air cleaner case. Service and Repair

5. Move the water hose from the PCM cover slightly out of the way.

6. Remove in the order indicated in the table.

Factory service manual diagram





Factory service manual diagram




7. Install in the reverse order of removal.

8. When replacing the PCM on the vehicles, perform the following:

- PCM parameter reset Keyless Entry System Advanced Keyless Entry And Start System

PCM Connector Connected Note

CAUTION:
- If the PCM connector is inserted at an angle and the lever is moved, the connector could be damaged. Verify that the PCM connector is inserted straight.

Factory service manual diagram




1. Verify that the PCM connector lever is tilted towards the wiring harness side as shown in the figure.

Factory service manual diagram





2. Insert the PCM connector straight until it contacts the PCM and verify that the lever reverts upward naturally.

3. Push the lever until a click is heard.

Factory service manual diagram





Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.