2012 Mazda MX-5 Miata L4-2.0LFACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor/Switch (For Computer): Testing and Inspection





ENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION [LF]

NOTE:
- Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. Description and Operation

Resistance Inspection

1. Remove the battery cover.

2. Disconnect the negative battery cable. Removal and Replacement

3. Disconnect the ECT sensor connector.

4. Remove the ECT sensor. Service and Repair

5. Place the ECT sensor in the water and while increasing the water temperature, measure the resistance between ECT sensor terminals A and B.

- If the monitor item status/specification (reference) is not within the specification, even though the ECT sensor resistance is within the specification, perform the "Circuit Open/Short Inspection".
- If not within the specification, replace the ECT sensor. (See Service and Repair)

Standard

Factory service manual diagram




Circuit Open/Short Inspection

Factory service manual diagram




Factory service manual diagram




1. Disconnect the PCM connector. Service and Repair

2. Inspect the following wiring harnesses for an open or short circuit. (Continuity inspection)

Open circuit

- If there is no continuity, there is an open circuit. Repair or replace the wiring harness.

- ECT sensor terminal A and PCM terminal 2AH
- ECT sensor terminal B and PCM terminal 2AY

Short circuit

- If there is continuity, there is a short circuit. Repair or replace the wiring harness.

- ECT sensor terminal A and power supply
- ECT sensor terminal A and body ground
- ECT sensor terminal B and power supply

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.