Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mazda MX-5 Miata L4-2.0LFACTORY OEM SERVICE PROCEDURE
Clearing Advanced Key
CLEARING ADVANCED KEY
1. Fully lower the driver-side door glass.
2. Connect the M-MDS to the DLC-2.
3. Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.
CAUTION:
- Protect the cable and body contact area with a clean rag, otherwise they could be damaged.
4. After vehicle identification, select the following from the M-MDS initial screen.
- Using an IDS (laptop PC)
- Select "Body".
- Select "Security".
- Select "PATS Functions".
- Using a PDS (pocket PC):
- Select "Programming".
- Select "PATS Functions".
5. Then, select an item from the screen menu.
- Card Key Code Erase and Program
6. Perform the security access according to the directions on the M-MDS screen.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
