2012 Mazda CX-7 AWD L4-2.3L TurboFACTORY OEM SERVICE PROCEDURE

Vehicle Speed Sensor: Testing and Inspection





VEHICLE SPEED SENSOR (VSS) INSPECTION [AW6A-EL, AW6AX-EL]

On-Vehicle Inspection

CAUTION:
- Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.
- Do not damage the terminals.

1. Disconnect the negative battery cable.

2. Remove the air cleaner component. Service and Repair

3. Remove the TCM. Service and Repair

4. Verify that there is no continuity between the coupler component terminals B19 and GND or B20 and GND.

Factory service manual diagram





Factory service manual diagram





- If there is any malfunction, inspect the coupler component.
- If the coupler component is normal, replace the ATX. Automatic Transaxle Removal/Installation

NOTE:
- Inspect with a tester that can indicate more than 10 megohms and confirm that the value is more than 1 megohm.

5. Verify that there is continuity between coupler component terminals B19 and B20.

Factory service manual diagram





Factory service manual diagram





- If there is any malfunction, inspect the coupler component.
- If the coupler component is normal, replace the ATX. Automatic Transaxle Removal/Installation

6. Install the TCM. Service and Repair

7. Install the air cleaner component. Service and Repair

8. Connect the negative battery cable.

9. Perform the neutral position learning. Programming and Relearning

Off-Vehicle Inspection

CAUTION:
- Do not damage the terminals.

1. Connect the VSS terminal 2 to the battery positive terminal, connect the battery negative terminal to VSS terminal 1 through an ammeter set to a resistance of 100 ohm.

Factory service manual diagram





2. Measure the current while waving a magnet back and forth over the top of the VSS (less than 5 mm {0.197 in}).

Factory service manual diagram





- If there is any malfunction, replace the VSS. Service and Repair

VSS

Factory service manual diagram




3. Perform the mechanical system test. Mechanical System Test

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.