Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mazda 6 i Touring PlusFACTORY OEM SERVICE PROCEDURE
Component Locations
Select a section or procedure below to view factory instructions:
Air Bag SystemAntilock Brake System And Dynamic Stability Control SystemAutomatic Transaxle (AY6A-El)Automatic Transaxle (FS5A-El)Automatic Transaxle Shift MechanismBody Control SystemBody PanelsBrake SystemCharging System (MZI 3.7 V6)Charging System (MZR 2.5)Doors And LiftgateDriveshaftEmission System (MZI 3.7 V6)Emission System (MZR 2.5)Engine Control System (MZI 3.7 V6)Engine Control System (MZR 2.5)Engine Cooling System (MZI 3.7 V6)Engine Cooling System (MZR 2.5)Engine Mechanical (MZI 3.7 V6)Engine Mechanical (MZR 2.5)Engine Mechanical Intake-Air System (MZI 3.7 V6)Engine Mechanical Intake-Air System (MZR 2.5)Engine Mechanical Lubrication System (MZI 3.7 V6)Engine Mechanical Lubrication System (MZR 2.5)Entertainment SystemExterior Trim SystemFront Axle Hub And BearingFront Suspension SystemFuel System (MZI 3.7 V6)Fuel System (MZR 2.5)Glass/Windows/MirrorsHVAC Basic SystemHVAC (Full Auto Air Conditioner) Control SystemHVAC (Manual Air Conditioner) Control SystemIgnition System (MZI 3.7 V6)Ignition System (MZR 2.5)Instrumentation/Driver InfoInterior Trim SystemLighting SystemManual Transaxle (G66M-R)Manual Transaxle Shift Mechanism (G66M-R)Manual Transaxle Clutch (G66M-R)Parking Brake SystemPower Steering SystemPower SystemsRear Axle And Wheel HubRear Suspension SystemSeat Belt SystemSeat SystemSecurity System And Locks SystemStarting System (MZI 3.7 V6)Starting System (MZR 2.5)Sunroof System
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.