Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mazda 6 L4-2.5LFACTORY OEM SERVICE PROCEDURE
Power Steering Pressure Switch: Testing and Inspection
POWER STEERING PRESSURE (PSP) SWITCH INSPECTION [MZR 2.5]
1. Inspect the following if the power steering is inoperative: Testing and Inspection
- Power steering fluid level
- Power steering fluid leakage
- Power steering fluid pressure
2. Disconnect the negative battery cable. Removal and Replacement
3. Disconnect the PSP switch connector.
4. Reconnect the negative battery cable. Removal and Replacement
5. Start the engine.
6. Inspect for continuity between PSP switch terminal A and body ground.
- If not as specified, replace the PSP switch. Overhaul
PSP switch specification
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
