Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mazda 6 L4-2.5LFACTORY OEM SERVICE PROCEDURE
Clutch Fluid: Service and Repair
CLUTCH FLUID AIR BLEEDING/REPLACEMENT [G66M-R]
CAUTION:
- Fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If fluid does get on painted surfaces, wipe it off immediately.
- Keep the fluid level in the reserve tank at 3/4 full or more during air bleeding.
- Do not mix different types of fluid, otherwise the clutch may not operate normally.
- Do not reuse old fluid, otherwise the clutch may not operate normally.
NOTE:
- When replacing the fluid, drain the old fluid, fill the reserve tank with new fluid and then perform Steps 1-11 below.
Specified fluid
- SAE J1703 or FMVSS116 DOT-3
1. Remove the aerodynamic under cover No.2. Aerodynamic Under Cover No. 2 Removal/Installation
2. Remove the bleeder cap from the clutch release cylinder, and connect a vinyl hose to the bleeder plug.
3. Place the other end of the vinyl hose in a clear container, and fill fluid in the container during air bleeding.
4. Working with two people, one should depress the clutch pedal a few times and then depress and hold the pedal down.
5. While the clutch pedal is being held down, the other person should loosen the bleeder screw using the commercially available flare nut wrench, and bleed any fluid containing air bubbles. Once completed, tighten the bleeder screw.
6. Continue to perform Steps 4 and 5 until no air comes from the vinyl hose.
7. Tighten the bleeder screw using the commercially available flare nut wrench. Tightening torque
- 5.9-8.8 Nm {61-89 kgf-cm, 53-77 in-lbf}
8. Install the bleeder cap.
9. Fill the reserve tank to MAX with the specified fluid.
10. Perform the following inspections:
- Clutch operation
- Clutch fluid leakage
- Clutch fluid level
11. Install the aerodynamic under cover No.2. Aerodynamic Under Cover No. 2 Removal/Installation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
