2012 Mazda 5 TouringFACTORY OEM SERVICE PROCEDURE

Quarter Window Glass Removal: Notes

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Rear package tray lid (See REAR PACKAGE TRAY LID REMOVAL/INSTALLATION .)
    2. Sub trunk (See SUB-TRUNK REMOVAL/INSTALLATION .)
    3. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
    4. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    5. Rear header trim (See REAR HEADER TRIM REMOVAL/INSTALLATION .)
    6. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
    7. Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION .)
    8. Cargo compartment light (See CARGO COMPARTMENT LIGHT REMOVAL/INSTALLATION .)
    9. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
    10. Second-row seat belt upper anchor installation bolt (See SECOND-ROW SEAT BELT REMOVAL/INSTALLATION .)
    11. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
    12. Center guide rail cover (See CENTER GUIDE RAIL COVER REMOVAL/INSTALLATION .)
  3. Apply protective tape along the edge of the body and the quarter window glass.
    Fig 1: Identifying Protective Tape Applying Dimensions At Edge Of Body And Quarter Window Glass
    G08152844
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.