2012 Mazda 5 TouringFACTORY OEM SERVICE PROCEDURE

Check code 09

Inspection item Step Inspection condition Display Action
Clock switch input signal 1 H switch is pressed
G08153597
 The input signal is normal.
Go to the next step.
G08153598
 Go to the next step.
H switch is released
G08153599
 Go to Step 4.
G08153600
 The input signal to the information display is normal.
Go to Step 2.
2 M switch is pressed
G08153601
 The input signal is normal.
Go to the next step.
G08153602
 Go to the next step.
M switch is not released
G08153603
 Go to Step 5.
G08153604
 The input signal to the information display is normal.
Go to Step 3.
Clock switch input signal 3 :00 switch is pressed
G08153605
 The input signal is normal.
Go to the next step.
G08153606
 Go to the next step.
:00 switch is released
G08153607
 Go to Step 6.
G08153608
 The input signal to the information display is normal.
4 Inspect the clock switch. 
  • Verify the resistance between H switch terminals.

    (See CLOCK SWITCH INSPECTION .)

  • Can the resistance be measured?
 Yes
  • Replace the information display.
No
  • Inspect for an open or short circuit in the clock switch related wiring harness, poor connection or terminal disconnection of the connector.
  • If there is any malfunction, repair or replace the malfunctioning location.
Clock switch input signal 5 Inspect the clock switch. 
  • Verify the resistance between M switch terminals.

    (See CLOCK SWITCH INSPECTION .)

  • Can the resistance be measured?
 Yes
  • Replace the information display.
No
  • Inspect for an open or short circuit in the clock switch related wiring harness, poor connection or terminal disconnection of the connector.
  • If there is any malfunction, repair or replace the malfunctioning location.
6 Inspect the clock switch. 
  • Verify the resistance between: 00 switch terminals.

    (See CLOCK SWITCH INSPECTION .)

  • Can the resistance be measured?
 Yes
  • Replace the information display.
No
  • Inspect for an open or short circuit in the clock switch related wiring harness, poor connection or terminal disconnection of the connector.
  • If there is any malfunction, repair or replace the malfunctioning location.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.