Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Mazda 5 TouringFACTORY OEM SERVICE PROCEDURE

Check code 08

Inspection item	Step	Inspection condition	Action
INFO switch input signal	1	INFO switch is pressed	The input signal is normal. Go to the next step.
	1	INFO switch is pressed	Go to the next step.
	2	INFO switch is released	Go to the next step.
	2	INFO switch is released	The input signal to the information display is normal.
	3	Inspect the steering switch. Measure the resistance between steering switch terminal K and M. (See STEERING SWITCH INSPECTION .) Can the resistance be measured?	Yes	Replace the information display.
	3		No	Inspect for an open or short circuit in the steering switch related wiring harness, poor connection or terminal disconnection of the connector. If there is any malfunction, repair or replace the malfunctioning location.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.