2012 Mazda 5 TouringFACTORY OEM SERVICE PROCEDURE

No.1 Additional Key Programming Procedure (Using Two Valid Keys): Procedure

Fig 1: Valid Keys Procedure Chart
G08153115
Step Procedure Action after procedure
1 LAUNCH PROGRAMMING MODE 
  • Switch the ignition ON using key 1.
  • After verifying that the security indicator light illuminates for approx. 3 s and turns off, switch the ignition OFF (LOCK) within approx. 4 s.
  • Remove key 1.
  • Switch the ignition ON using key 2.
  • After verifying that the security indicator light illuminates for approx. 3 s and turns off, switch the ignition OFF (LOCK) within approx. 4 s.
  • Remove key 2.
Go to the next step.
2 PERFORM ADDITIONAL KEY PROGRAMMING 
  • Switch the ignition ON using key 3.
  • Verify that the security indicator light illuminates for approx. 3 s, and then turns off.
  • Remove key 3.
  • Switch the ignition OFF (LOCK).
  • Are there other keys to be programmed?
Yes Go back to Step 1.
No Go to the next step.
3 VERIFY THAT KEY IS PROGRAMMED 
  • Verify that the engine can start and run for approx. 5 s or more using all the programmed keys.
NOTE:
  • When verifying that the engine starts, wait approx. 5 s or more before starting the engine using the next key.
Procedure is completed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.