Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mazda 3 L4-2.5LFACTORY OEM SERVICE PROCEDURE
Immobilizer System (Advanced Keyless Entry And Push Button Start System)
FOREWORD [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)]
- If there is any vehicle malfunction complaint lodged by a customer, perform malfunction diagnosis according to the troubleshooting procedure.
- Due to the possibility that the engine cannot be started because transmission between the key and the vehicle is obstructed, do not allow the following items to contact the key ring.
- Any metallic object
- Spare keys or keys for other vehicles equipped with an immobilizer system
Troubleshooting Procedure
*1
Controller Area Network (CAN) Malfunction Diagnosis Flow [Multiplex Communication System]
*2
DTC Inspection Note
Action for non-repeatable malfunction
- If the malfunction does not recur, verify the malfunction cause by performing the following actions:
- Based on the repair order form, attempt to drive the vehicle or perform tests to replicate the malfunction, record the data (such as keyless control module circuit voltage) at that time, and detect the malfunction cause.
- Shake the wiring harness or connector of the electrical component which is suspected to be the cause of the malfunction, and inspect for malfunction or occurrence of any DTCs.
- Inspect the female terminals on the connector of the electric component which is suspected to be the cause of the malfunction for poor connection.
DTC Inspection Note
- When there is a malfunction in the immobilizer system, DTCs are recorded in the keyless control module and PCM. Immobilizer System (Advanced Keyless Entry And Push Button Start System)
- There are two methods of DTC verification: One is by the number of times the security light flashes and the other is by using the M-MDS.
- If immobilizer system DTCs are not recorded even if the engine cannot be started, perform symptom troubleshooting. No. 3 Will Not Crank No. 3 Will Not Crank
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
