2012 Mazda 2 L4-1.5LFACTORY OEM SERVICE PROCEDURE

Power Window Main Switch Inspection





POWER WINDOW MAIN SWITCH INSPECTION

1. Switch the ignition to ON.

2. Verify that the door glass (driver's side) can be operated forapprox. 43 s after the ignition switched to off.

- If the door glass (driver's side) cannot be operated forapprox. 43 s after the after the ignition switched to off, of if the door glass (driver's side) can still be operated afterapprox. 43 s, replace the power window main switch.

3. Disconnect the negative battery cable.

4. Remove the inner garnish. (See Inner Garnish Removal/Installation.)

5. Remove the front door trim. (See Front Door Trim Removal/Installation.)

6. Remove the switch panel. (See Overhaul.)

7. Connect the power window main switch connector.

8. Connect the negative battery cable.

9. Measure the voltage at each terminal.

- If the voltage is not as specified in the terminal voltage table, inspect the parts under Inspection item(s) and related wiring harnesses.

10. If the system does not work normally even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window main switch.

Factory service manual diagram





Terminal Voltage Table (Reference)

Factory service manual diagram




Factory service manual diagram




Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.