Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
Spark Plug: Service and Repair
SPARK PLUG REMOVAL/INSTALLATION [13B-MSP]
CAUTION:
- If a spark plug that is not as specified is installed, engine performance will be deteriorated. Install only the specified spark plug when replacing.
1. Remove the engine cover. Service and Repair
2. Remove the battery cover. Removal and Replacement
3. Disconnect the negative battery cable. Removal and Replacement
4. Disconnect the high-tension leads from the spark plugs. Service and Repair
5. Remove the spark plugs using a plug-wrench.
CAUTION:
1 Install spark plugs marked with white (standard type plug) or orange (hot type plug) paint on the leading side and spark plugs with blue paint on the trailing side.
NOTE:
1 It is easier to remove some spark plugs from beneath the vehicle.
6. Install in the reverse order of removal.
Tightening torque
- 12.8-17.7 Nm {131-180 kgf-cm, 114-156 in-lbf}
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.