2011 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE

Ignition Cable: Testing and Inspection




HIGH-TENSION LEAD INSPECTION [13B-MSP]

1. Remove the high-tension lead. Service and Repair

2. Measure the resistance using a tester.
1 If not within the specification, replace the high-tension lead.

High-tension lead resistance [20 °C {68 °F}]
- 1.0-4.0 kilohms

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.