Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
Engine Oil: Testing and Inspection
ENGINE OIL LEVEL INSPECTION [13B-MSP]
1. Position the vehicle on level ground.
2. Warm up the engine.
3. Stop the engine and allow at least 5 min before continuing.
4. Remove the service hole cover attached to the engine cover using the following procedure.
a. Press the tab of the service hole cover toward the vehicle front.
b. Lift up the service hole cover.
5. Remove the dipstick, wipe it cleanly, and reinstall it fully.
6. Remove the dipstick and verify that the oil level is between the F and L marks on the dipstick.
- If the oil level is below the L mark, add engine oil.
NOTE:
- The dipstick is graduated in 0.5 L {0.5 US qt, 0.4 lmp qt} intervals as a reference for oil replenishment.
7. Install the dipstick.
8. Install the service hole cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.