Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
Alignment: Specifications
FRONT WHEEL ALIGNMENT
Specification (Unloaded Condition)
Front wheel alignment [Standard suspension]
Front wheel alignment [Sport suspension]
NOTE:
- Unloaded vehicle: Fuel tank is full. Engine coolant and engine oil are at specified level. Jack and tools are in designated position.
- Difference between the left and right dimension for camber and caster is within 1°.
REAR WHEEL ALIGNMENT
Specification (Unloaded Condition)
Rear wheel alignment [Standard suspension]
Rear wheel alignment [Sport suspension]
NOTE:
- Unloaded vehicle: Fuel tank is full. Engine coolant and engine oil are at specified level. Jack and tools are in designated position.
- Difference between the left and right camber angle is within 1°.
Ride Height
Measure height H from the center of the wheel to the fender brim.
Verify that the difference between the left and right dimension H is within the specification.
Standard 10 mm {0.39 in} or less
Specification (Unloaded Condition)
Front wheel alignment [Standard suspension]
Front wheel alignment [Sport suspension]
NOTE:
- Unloaded vehicle: Fuel tank is full. Engine coolant and engine oil are at specified level. Jack and tools are in designated position.
- Difference between the left and right dimension for camber and caster is within 1°.
REAR WHEEL ALIGNMENT
Specification (Unloaded Condition)
Rear wheel alignment [Standard suspension]
Rear wheel alignment [Sport suspension]
NOTE:
- Unloaded vehicle: Fuel tank is full. Engine coolant and engine oil are at specified level. Jack and tools are in designated position.
- Difference between the left and right camber angle is within 1°.
Ride Height
Measure height H from the center of the wheel to the fender brim.
Verify that the difference between the left and right dimension H is within the specification.
Standard 10 mm {0.39 in} or less
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.