Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
Cruise Control Switch: Testing and Inspection
CRUISE CONTROL SWITCH INSPECTION [13B-MSP]
1. Disconnect the negative battery cable and wait for 1 min or more.
2. Remove the driver-side air bag module. Driver-Side Air Bag Module Removal/Installation
3. Disconnect the cruise control switch connector. Service and Repair
4. Inspect for resistance and continuity between cruise control switch terminals G-F using a tester.
- If not as specified, replace the audio control switch. Service and Repair
5. Apply battery positive voltage to cruise control switch terminal E, and connect terminal D to ground.
6. Verify that the LED illuminates.
- If the LED does not illuminate, replace the audio control switch. Service and Repair
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
