Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mazda CX-9 AWD V6-3.7LFACTORY OEM SERVICE PROCEDURE
Timing Component Alignment Marks: Locations
Timing Component Alignment Marks

LH

RH

Verify that the crankshaft keyway is at 11 o'clock position.

NOTE:
- Of the three marked locations on the timing chain, align the mark that has a different color to the crankshaft sprocket side timing mark.
2. If the timing marks on the timing chain are not evident, place timing marks on the timing chain using an indelible ink marker.

NOTE:
- The marked external links are not included in the count.
- When marking the crankshaft sprocket side timing chain (No.3), change the mark color.
The number of external links
- No.1-2 : 38
- No.2-3 : 33
- No.3-1 : 27
3. Place alignment marks on the timing chain corresponding to each of the alignment marks on the timing sprocket.

LH
RH
Verify that the crankshaft keyway is at 11 o'clock position.
NOTE:
- Of the three marked locations on the timing chain, align the mark that has a different color to the crankshaft sprocket side timing mark.
2. If the timing marks on the timing chain are not evident, place timing marks on the timing chain using an indelible ink marker.
NOTE:
- The marked external links are not included in the count.
- When marking the crankshaft sprocket side timing chain (No.3), change the mark color.
The number of external links
- No.1-2 : 38
- No.2-3 : 33
- No.3-1 : 27
3. Place alignment marks on the timing chain corresponding to each of the alignment marks on the timing sprocket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
