Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mazda 6 s Touring PlusFACTORY OEM SERVICE PROCEDURE
Rear Abs Wheel-Speed Sensor Removal/Installation
- Remove the rear seat cushion. (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
- Remove the rear side seat back. (See REAR SIDE SEAT BACK REMOVAL/INSTALLATION .)
- Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION .)
- Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
- Disconnect the rear ABS wheel-speed sensor connector.
- Press the rear ABS wheel-speed sensor tabs and press out the sensor toward the outside of the vehicle.
- Remove in the order indicated in the table.
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.