Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2011 Mazda 6 s Touring PlusFACTORY OEM SERVICE PROCEDURE

DSC Off Switch Inspection

Remove the DSC OFF switch. (See DSC OFF SWITCH REMOVAL/INSTALLATION .)
Verify that the continuity between the DSC OFF switch terminals is as indicated in the table.
- If not as indicated in the table, replace the DSC OFF switch.
Fig 1: DSC OFF Switch Terminal Continuity Chart
Courtesy of MAZDA MOTORS CORP.
Apply battery voltage to DSC OFF switch terminal E, and connect terminal A to ground.
Verify that the LED illuminates.

If there is any malfunction, replace the DSC OFF switch.

Fig 2: DSC OFF Switch Circuit

Courtesy of MAZDA MOTORS CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.