Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mazda 6 i Touring PlusFACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | 4.00 OZS. | 0.11 L | PAG 46 | S | |||
| Air Cond Refrigerant | 1.10 LBS. | 0.49 KG | R-134a | S | |||
| Automatic Transmission Fluid | 2.5L Eng | 8.60 QTS. | 8.13 L | MAZDA Genuine ATF M-V | S | ||
| Brake Fluid | N/A | N/A | DOT 3 Brake Fluid | Fill to line on reservoir. | S | ||
| Engine Coolant | 2.5L Eng | 9.40 QTS. | 8.89 L | FL22 Type Engine Coolant | If the "FL22" mark is shown on or near the cooling system cap, use Mazda Genuine FL22 engine coolant. FL22 type engine coolant is shipped as a diluted solution. Use the solution as is when replacing coolant. | S | |
| Engine Oil | 2.5L Eng | w/Filter | 5.30 QTS. | 5.01 L | API - ILSAC, SAE 0W-20 Engine Oil | S | |
| Engine Oil | 2.5L Eng | w/o Filter | 4.90 QTS. | 4.63 L | API - ILSAC, SAE 0W-20 Engine Oil | S | |
| Fuel Tank | 18.50 GALS. | 70.03 L | S | ||||
| Manual Transmission Fluid | 3.01 QTS. | 2.84 L | API - GL-4 or GL-5, SAE 75W-90 (Any temperature). API - GL-4 or GL-5, SAE 80W-90 (Temperature above 50Deg.F) | S | |||
| Windshield Washer Fluid | N/A | N/A | Ultra-Clear Windshield Washer Fluid | S | |||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.