2011 Mazda 3 Mazdaspeed, 2.3 4FACTORY OEM SERVICE PROCEDURE

Keyless Entry System

IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC PCM Description Reference
B10D9:87 P 1260:00 Communication error with coil antenna (See SECURITY LIGHT: 11, DTC: B10D9:87/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
B10D5:13 P1260:00 Coil antenna malfunction (See SECURITY LIGHT: 12, DTC: B10D5:13/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
B10D7:05 P1260:00 Key ID number error (See SECURITY LIGHT: 13, DTC: B10D7:05/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
B10D7:94 P1260:00 (See SECURITY LIGHT: 13, DTC: B10D7:94/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
B10D7:81 P 1260:00 Receiving erratic serial data (See SECURITY LIGHT: 14, DTC: B10D7:81/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
B10D7:51 P1260:00 Unprogrammed key ID number (See SECURITY LIGHT: 15, DTC: B10D7:51/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
U0100:87 P1260:00 Communication error with PCM (No response) (See SECURITY LIGHT: 16, DTC: U0100:87/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
B10D8:00 P1260:00 Shortage of programmed key (See SECURITY LIGHT: 21, DTC: B10D8:00/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
B10DA:51 P1260:00 Communication error with PCM (Data transfer failure) (See SECURITY LIGHT: 22, DTC: B10DA:51/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
B10DA:62 P 1260:00 Communication error with PCM (Data mis-match) (See SECURITY LIGHT: 23, DTC: B10DA:62/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] ).
U0001:88 110073:00 Module communication error (HS-CAN) (See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] ).
U0100:00 - Communication error with PCM
U3000:41 - Instrument cluster internal malfunction (See DTC U3000:41 [INSTRUMENT CLUSTER] ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.