SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 193 (ENGINE CONTROL SYSTEM)PCM INSPECTIONFREEZE FRAME DATA MONITOR TABLEFREEZE FRAME DATA WHEN PENDING CODE IS SET
2011 Mazda 3 Mazdaspeed, 2.3 3

Freeze frame data when pending code is set

2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Freeze frame data when pending code is set
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  • Retrieve the following FFD from PID/DATA MONITOR & RECORD.
    NOTE:
    • The data will remain in the memory even if another emission-related DTC is stored, including the Misfire and Fuel System Monitor DTCs.
      Fig 1: Freeze Frame Data Monitor Table (When Pending Code Is Set)
      G00993845Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.