2011 Mazda 3 Mazdaspeed, 2.3 3FACTORY OEM SERVICE PROCEDURE

Fuel Pressure Sensor Inspection

  1. Connect the M-MDS to the DLC-2.
  2. Switch the ignition to ON (Engine off).
  3. Select the FUEL_PRES PID on the M-MDS.
  4. After warming up the engine, verify that the FUEL_PRES PID is at the standard value under the following conditions.
    • If not as verified, replace the fuel delivery pipe.
    Step Condition FUEL_PRES PID
    1
    • Idle
    • 90 s after engine is started
    Approx. 3 MPa
    2
    • Idle
    • Spill valve solenoid valve connector is disconnected
    Approx. 530 kPa
  5. After connecting the spill valve control solenoid valve connector, clear the DTC.
    Fig 1: Identifying DLC-2
    G07868475Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.