Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mazda 3 Mazdaspeed, 2.3 3FACTORY OEM SERVICE PROCEDURE
ECT Sensor No. 1 Inspection
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3 WITH TC] ).
- Disconnect the negative battery cable.
- Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS ).
- Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [L3 WITH TC] ).
- Disconnect the ECT sensor No. 1 connector.
- Remove the ECT sensor No. 1. (See ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION ).
- Place the ECT sensor No. 1 in water with a thermometer, and heat the water gradually.
- Measure the resistance between the ECT sensor No. 1 terminals A and B using an ohmmeter.
- If not as specified, replace the ECT sensor No. 1.
(See ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION ).
ECT SENSOR NO. 1 SPECIFICATIONECT (°C {°F}) Resistance (kilohms) 20{68} Approx. 37.3 80{176} Approx. 3.84 - If not as specified, replace the ECT sensor No. 1.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
