Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mazda 3 Mazdaspeed, 2.3 3FACTORY OEM SERVICE PROCEDURE
Body Control Module (BCM) Removal/Installation: MTX
- Perform the BCM configuration when replacing it. (See BODY CONTROL MODULE (BCM) CONFIGURATIONΒ ).
- Disconnect the negative battery cable.
- Remove the following parts:
- Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION ).
- Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
- Upper panel (See UPPER PANEL REMOVAL/INSTALLATION ).
- Shift knob (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION ).
- Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION ).
- Side wall (See SIDE WALL REMOVAL/INSTALLATION ).
- Console (See CONSOLE REMOVAL/INSTALLATION ).
- Set the hood release lever out of the way. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION ).
- Remove the lower panel, (driver-side) (See LOWER PANEL REMOVAL/INSTALLATION ).
- Remove the starter cut relay, (with advanced keyless entry and push button start system) (see STARTER CUT RELAY REMOVAL/INSTALLATION [MTX] ).
- Remove the nuts shown in the figure.
- Pry off the lock device of the clip while pressing the tab in the position shown in the figure.
- Rotate the clip in the direction of the arrow shown in the figure.
- Remove the clip by pulling it in the direction of the arrow shown in the figure.
- Disconnect the connector shown in the figure.
- While pressing the tab shown in the figure, pull the bracket in the direction of the arrow and remove it.
- Remove the BCM.
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
