2011 Mazda 3 Mazdaspeed, 2.3 3FACTORY OEM SERVICE PROCEDURE

Pattern 1

  • Terminal:
    • Bonnet latch switch signal: 1J (+) <==> body ground (-)
    • Rear door switch (LH) signal: 6E (+) <==> body ground (-)
    • Front door switch (driver side) signal: 6G (+) <==> body ground (-)
    • Front door switch (passenger side) signal: 6H (+) <==> body ground (-)
    • Lock input (Driver-side door lock-link switch): 61 (+) <==> body ground (-)
    • Lock/unlock input (passenger-side door lock-link switch) (rear door lock link switch (RH, LH)): 6J (+) <==> body ground (-)
    • Rear door switch (RH) signal: 6K (+) <==> body ground (-)
    • Unlock input (Driver-side door lock-link switch): 6L (+) <==> body ground (-)
  • Oscilloscope setting: 1 V/DIV (Y), 1 ms/DIV (X), DC range
    Fig 1: Screen Display - Generated Pulse Pattern 1
    G06732678Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.