TRANSAXLE RANGE (TR) SWITCH INSPECTION [FS5A-EL]

CAUTION:
- Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

Operation Inspection

1. Perform the following procedures to inspect the TR switch.

- If there is any malfunction, adjust the TR switch. Adjustments

a. Engage the parking brake and use wheel chocks at the front and rear of the wheels.

b. Verify that the starter operates only when the ignition is switched to START with the selector lever in the P position or the N position.

c. Verify that the back-up lights illuminate when shifted to the R position with the ignition at ON.

d. Verify that the positions of the selector lever and the selector indicator light are aligned.

On-Vehicle Inspection

1. Engage the parking brake and use wheel chocks at the front and rear of the wheels.

2. Perform the following procedures.
a. Remove the battery cover. Removal and Replacement

b. Disconnect the negative battery cable.

c. Remove the air cleaner component. Service and Repair

d. Disconnect the TR switch connector.

3. Inspect continuity as indicated in the table.

- If there is any malfunction, adjust the TR switch. Adjustments

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Transmission Position Sensor/Switch: Testing and Inspection

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?