2010 Mazda CX-9 Touring, 3.7 V, AWDFACTORY OEM SERVICE PROCEDURE

DTC Inspection [Advanced Keyless Entry And Start System]

  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Self Test".
      2. Select "Modules".
      3. Select "RKE".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "RKE".
      3. Select "Self Test".
        Fig 1: Identifying Data Link Connector - 2 Location
        G04970667Courtesy of MAZDA MOTORS CORP.
  3. Verify the DTC according to the directions on the screen.
    • If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
  4. After completion of repairs, clear all DTCs stored in the keyless control module. (See CLEARING DTC [ADVANCED KEYLESS ENTRY AND START SYSTEM]Β .)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.