Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Mazda 6 L4-2.5LFACTORY OEM SERVICE PROCEDURE
Auto Light/Wiper Control Module Inspection - Lighting Systems
2010 -
Mazda6 -
Body and Accessories
AUTO LIGHT/WIPER CONTROL MODULE INSPECTION
1. Measure the voltage at the auto light/wiper control module terminals as indicated below.
Terminal Voltage List (Reference)
Terminal Voltage List (Reference) (Part 1):
Terminal Voltage List (Reference) (Part 2):
Terminal Voltage List (Reference) (Part 3):
*1
For vehicles with DRL only.
*2
With auto light system
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.