2010 Mazda 6 L4-2.5LFACTORY OEM SERVICE PROCEDURE

Flywheel

Gradually tighten the flywheel lock bolts in a crisscross pattern.

Factory service manual diagram





Tighten the lock bolts in three steps in the order shown in the figure.

Tightening torque
1st: 46-54 Nm {4.7-5.5 kgf-m, 34-39 ft-lbf}
2nd: 76-84 Nm {7.8-8.5 kgf-m, 57-61 ft-lbf}
3rd: 108-116 Nm {11.1-11.8 kgf-m, 80-85 ft-lbf}
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.