SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 597 (GLASS/WINDOWS/MIRRORS)POWER WINDOW SUBSWITCH REMOVAL/INSTALLATIONPASSENGER'S SIDE
2010 Mazda 5 Sport, 2.3 L, Standard

Passenger's Side

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Passenger's Side
WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
  2. Disconnect the negative battery cable.
  3. Remove the cover, then remove the screw.
  4. Detach clips B using a tape-wrapped flathead screwdriver.
  5. Detach tab A by pulling it in the direction of the arrow, and remove the switch panel from the door trim.
  6. Disconnect the power window subswitch connector.
    Fig 1: Identifying Power Window Subswitch Remove / Install Components
    G05545676Courtesy of MAZDA MOTORS CORP.
  7. Remove the screws, then remove the power window subswitch.
  8. Install in the reverse order of removal.
    Fig 2: Identifying Power Window Subswitch And Screw
    G05545672Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.