Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Mazda 5 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Engine Control Module: Service and Repair
PCM REMOVAL/INSTALLATION [L3]
1. When replacing the PCM, perform the following:
- PCM configuration Programming and Relearning
2. Remove the battery cover, battery duct, battery and battery tray with PCM. Removal and Replacement
3. Disconnect the PCM connector.
4. Remove the PCM from the battery tray.
5. When replacing the PCM on the vehicles, perform the following:
- PCM parameter reset Programming and Relearning
6. Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.