Auto Open/close Function (Driver's Side) Inspection

2010 Mazda 3 Mazdaspeed, 2.3 4SECTION Auto Open/close Function (Driver's Side) Inspection
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1
  • Switch the ignition to ON.
  • Operate the power window using the auto open/close function on the power window main switch.
  • Does the power window operate properly?
Yes Go to the next step.
No If the power window automatically opens during the closing operation: 

Others: 
2
  • Operate the power window main switch to the close position while the power window is opening.
  • Does the power window operation stop?
Yes Go to the next step.
No
  • Replace the power window main switch (power window control unit is malfunctioning.)
3
  • Operate the power window main switch to the open position while the power window is closing.
  • Does the power window operation stop?
Yes
  • Auto open/close function is normal.
  • Perform the IG-OFF timer function inspection.
No
  • Replace the power window main switch (power window control unit is malfunctioning.)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.