Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
AFS (Adaptive Front Lighting System) Control Module Removal/Installation
2010 Mazda 3 L4-2.5LSECTION AFS (Adaptive Front Lighting System) Control Module Removal/Installation
AFS (ADAPTIVE FRONT LIGHTING SYSTEM) CONTROL MODULE REMOVAL/INSTALLATION
NOTE:
- Perform the auto leveling system initialization after newly replacing the AFS control module to assure that the auto leveling system operates correctly.
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Passenger-side front scuff plate Front Scuff Plate Removal/Installation
b. Passenger-side front side trim Front Side Trim Removal/Installation
c. Dashboard under cover Dashboard Under Cover Removal/Installation
d. Grove compartment Service and Repair
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Perform the auto leveling system initialization after newly replacing the AFS control module. Programming and Relearning
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.