Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20103 L4-2.5LREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRWHEEL ALIGNMENT PRE-INSPECTION
2010 Mazda 3 L4-2.5L
Wheel Alignment Pre-Inspection
2010 Mazda 3 L4-2.5LSECTION Wheel Alignment Pre-Inspection
WHEEL ALIGNMENT PRE-INSPECTION
1. Park the vehicle on a level ground, in an unloaded condition*, and with the wheels straight forward.
*: Unloaded condition.Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
2. Inspect the tire pressure.
- Adjust to the recommended pressure if necessary. Specifications
3. Inspect the wheel bearing play.
- Correct if necessary. Testing and Inspection Rear Wheel Hub Component Inspection
4. Inspect the wheel runout.
- Correct if necessary. Specifications
5. Rock the vehicle, and verify that there is no looseness in the steering wheel joint and suspension ball joint.
6. Rock the vehicle, and verify that the shock absorber operates properly.
7. Measure height H from the center of the wheel to the fender brim.
8. Verify that the difference between the left and right dimension H is within the specification.
- If it exceeds the specification, repeat the Step 2-7.
- Standard
10 mm {0.39 in} or less
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.